Descrizione
Features:
RC lost Air plane finder helicopter Parkflyer tracer glider Aircraft Alarm
Connect the alarm between the servo and the receiver, i.e. act as a servo extension cord.
Turn on your TX. and you will hear 2 x beep sound.
Do not move any of the control stick on the TX or simply turn off the the TX. You will hear a continuous beep sound after 1 minute. It will stop once u turn on your TX or move the control stick.
If you ignore the continuous beep sound for around 2minutes, the beep sound will change the a louder V sound.
You need to disconnect the alarm from the receiver in order to switch of the alarm.
MAKE SURE THE CORRECT POLARITY BEFORE TURN ON THE TX
Product Properties:
Use: Vehicles & Remote Control Toys
Technical parameters: Value 2
For Vehicle Type: Airplanes
Tool Supplies: Grinded
Material: Rubber
Remote Control Peripherals/Devices: Motor
RC Parts & Accs: Connectors/Wiring
Upgrade Parts/Accessories: Gear
Item type: Tracer Alarm
Four-wheel Drive Attributes: Slot
Net weight: 5g
Size: 13.7*12*5mm
Packet content:
1 x RC lost plane finder helicopter parkflyer tracer
RC ha perso Aereo finder elicottero Parkflyer tracciante dell’aliante dei velivoli di allarme
Collegare l’allarme tra il servo e il ricevitore, ossia fungere da prolunga servo
Accendere il TX. e sentirete 2 x segnale acustico
Non spostare qualsiasi del bastone di comando sul TX o semplicemente spegnere il TX. Si sente un bip continuo dopo 1 minuto. Si fermerà una volta u accendere il TX o muovere il control stick
Se si ignora il segnale acustico continuo per circa due minuti, il segnale acustico cambierà il un suono più forte V.
